|
Locate gas supply valve (typically behind louvers,
below glass opening - may be red or blue).
|
Open valve by pivoting handle to be parallel to gas
line.
|
|
Locate pilot assembly with spark igniter (located
behind and below logs in the firebox - typically in the bottom center).
|
Then locate red or black igniter button.* Push igniter
to verify spark at pilot area.
|
|
Locate the black or green valve control knob (knob
with the words "ON", "OFF" and "PILOT" on it).
Push in and rotate counter-clockwise until the word "pilot" is in the 6
o'clock position.**
|
While pressing and holding in the valve knob (in "PILOT" position - it
should press in about 1/4"), press the red piezo button repeatedly (once per
second) until the pilot ignites. If the pilot does not light, wait 5
minutes and try again. Once the pilot is lit, continue to hold the valve
knob in for 30 seconds, then slowly release.
|
|
If the pilot light goes out, contact your nearest fireplace dealer
for service. Remember to shut the gas supply valve off (picture #1). If it
remains lit, press the valve knob in slightly and rotate counter-clockwise
until the word "ON" is in the 6 o'clock position.
|
Finally, turn the unit's ON/OFF switch (or wall switch
or remote control) to the "ON" position to start your
fire.
|
|
Enjoy your fireplace!
|
|
|
* |
If you do not see a red or black spark igniter button,
you do not have a manual ignition system. If power is actively supplied
to your fireplace, simply turn the on/off button, wall switch or remote
control to "on" to ignite your main burner. |
|
** |
Note: Some valve assemblies may be inverted in their
brackets. If yours appears to be the mirror image of picture #4, then
the word "PILOT" will be in the 12 o'clock position to light the pilot,
and "ON" will be set to the 12 o'clock position to turn on your main
burner. |
|
